Drive train parts wear out. They’re constantly moving. getting dirty, rubbing together, and inevitably they need replacing. I recently noticed that my chainring was worn to the point of being misshapen.

old-worn-chainring-2

You can see the teeth come to an extreme point, and the valleys between the teeth are no longer perfectly round. The chain and the ring should both be replaced, as they wear together. A new ring with an old chain or vice versa, will not fit together nicely and will actually accelerate the wear of your new part.

old-chain-removal-1

Step one, get rid of that old chain. The bicycle chain tool is made to push the pin out of a single link of chain. Normally if you plan to put the same chain back on, you need to be careful not to push the pin all the way out the other side. Since this chain is destined for the trash bin, crank it right through.

old-chainring-removal-1

Next, remove the chainring bolts. In this case they hold on a chainring guard as well. They mostly likely require a 4mm allen key, and if your bike has been through a few winters like this one, they’re likely seized and require some extra force.

narrow-wide-chainring-1

Since I’m running a single speed, I’m going to try out a narrow-wide chainring. This relatively new chainring design alternates narrow and wide teeth to fit perfectly between the narrow and wide links of a chain. The result is a tighter fit between the two, better chain retention, and hopefully a more efficient drive train.

narrow-wide-chainring-closeup-2

They’re most useful on geared mountain or cyclocross bikes with a single chainring, where there’s a much higher risk of dropping a chain. It should still give my single speed set up a better feel, and heck why not try out some new tech?

new-chainring-assembled-comp-1

Since this ring is a few teeth larger than my previous one, I left the guard off, and as a result I needed shorter chainring bolts. If you’re getting a new ring for an existing crank set, make sure the BCD (bolt circle diameter) and number of bolts matches. There are 4 and 5 bolt rings in different diameters, although only a handful are common.

When installing your new ring, check if the crank or ring manufacturer has a specified torque for the bolts. It may be stamped on the parts. If not, Park Tool recommends 70-95 in-lbs for steel and 44-88 in-lbs for aluminum. A torque wrench is a very handy thing to have in your tool box as it ensures your new parts will stay put and prevents damaging to components from over tightening.

Subscribe For Updates

Receive new products, special offers, and exciting news from Montague riders around the globe. We'll never share your email with anyone.

You have Successfully Subscribed!